Gas Turbine Design Software — Cycle Sizing
Size a jet or industrial gas turbine in your browser: RP-1311 gas properties, ARP-755A two-spool cycle matching, meanline stage design and component maps. Cycle plots included.
Sizing a gas turbine starts with a thermodynamic cycle and ends with a rotor that actually works. CFD Lab automates that middle: define compressor and turbine pressure ratios, fan and core spools, and firing temperature, and the cycle solver closes the mass, momentum and energy balance to give you a matched operating point with real gas properties rather than a constant-specific-heat approximation.
Gas properties come from RP-1311 reference equations, so the specific heat, enthalpy and entropy of the working fluid vary with temperature and pressure the way they do in reality. That matters most where the cycle is sensitive: the compressor polytropic efficiency and turbine expansion ratio both depend on variable specific heat, and a constant-specific-heat cycle can be several percent off in specific power.
The meanline stage stack takes matched pressures and temperatures and lays out blade counts, stage loading, flow coefficients and rotational speeds along the machine, then builds component maps for the fan, compressor, combustor and turbine. Run those maps against an ambient condition and you get thrust or shaft power, specific fuel consumption and a pressure-margin check that tells you whether the point is stable or choking.
For a two-spool architecture the cycle follows the ARP-755A convention: a high-pressure spool geared to the core, a low-pressure spool carrying the fan, and a power balance that couples them. The result is an engine-level answer — thrust, SFC, component operating points — that matches published anchors for engines in the CFM56 and GE90 classes.
Frequently asked questions
Can I size a whole engine cycle, not just a stage?
Yes. The cycle solver matches a two-spool configuration following the ARP-755A convention, closing the gas path from ambient through fan, HPC, combustor, HPT, LPT and nozzle, and returns thrust, SFC and per-component operating points.
Why use RP-1311 properties instead of constant specific heat?
Because c_p varies strongly with temperature across a turbine. Variable properties change the effective expansion ratio and the work per stage, which shifts the cycle matching and the specific fuel consumption by percent — enough to change a preliminary design decision.
Is this a substitute for a full 3D blade-row simulation?
No. The meanline plus map approach is the correct tool for preliminary sizing and for mapping a whole engine across its operating envelope. Detailed 3D row-by-row aerodynamics is a different and much larger problem.
Try it now
The page you are reading is a static, crawler-readable summary. The interactive tool runs in your browser — nothing is uploaded.
Open CFD Lab Back to home