Heat Transfer Simulation Online — Electronics Cooling

Browser-based thermal simulation for electronics: chip packages, PCBs, power electronics and batteries, with junction temperature, θJA and a ranked hotspot table.

Most heat-transfer questions in electronics come down to one number: will the hottest junction stay under its limit? The Electrical & Electronics module is built around that question. It follows the chain from electrical loss to heat to temperature, so you can see where the heat is generated, how it conducts through the board and package, and where it gets stuck.

The module is organised as an application explorer: six families broken into sixteen subgroups, covering chip packages, printed circuit boards, power electronics, EV batteries, server racks and cooling technologies. Each card states the typical problem, the physics it needs and the recommended geometry, so the set-up you start from matches the device you actually have.

You enter chip power, the film coefficient h, ambient temperature and board conductivity, and optionally switch on Joule heating with a terminal voltage when I²R loss matters. A steady 2D conduction solve then reports the maximum junction temperature, the temperature rise, the junction-to-ambient thermal resistance θJA, an energy-closure check, the five hottest components and the temperature drop across the die, thermal interface, lid and sink.

This is a screening tool and says so. A 2D conduction model with a prescribed film coefficient is the right first step before committing to a full 3D conjugate heat-transfer model with resolved airflow, and the set-up can be handed to the CFD pipeline when you reach that point. For internal convection in pipes and channels, use the pipe-flow studio instead.

Frequently asked questions

What is θJA?

The junction-to-ambient thermal resistance in kelvin per watt: how many degrees the junction rises above ambient for each watt dissipated. Lower is better.

Does it simulate the airflow around the board?

Not in the screening solve, which uses a prescribed film coefficient. Resolved airflow and conjugate heat transfer are done by handing the case to the CFD pipeline.

Try it now

The page you are reading is a static, crawler-readable summary. The interactive tool runs in your browser — nothing is uploaded.

Open CFD Lab Back to home