Marine Hydrodynamics CFD — Hull Resistance
Analyse hull resistance and free-surface flow in your browser: displacement, resistance components, powering and VOF free-surface CFD for ship design studies.
Ship resistance is the number that decides whether a design is commercial, and it decomposes into physically distinct parts: frictional resistance from the wetted surface skin friction, form resistance from the pressure field around the hull, and wave-making resistance from the free surface the hull pushes up.
CFD Lab models displacement-type hulls and reports the resistance components separately rather than as a single total, because the components respond to different design changes. Reducing skin friction means a smoother coating or a different hull form; reducing wave-making means changing the hull's volume distribution fore and aft. Averaging them into one number hides which lever is available.
Free-surface effects require a two-phase treatment, and the volume-of-fluid method with a level-set interface is what CFD Lab uses for the free-surface preview. This is the least mature part of the marine module and carries a preview badge accordingly — it is a credible tool for exploring wave-set-up and trim effects, not yet a substitute for a seakeeping code.
Powering follows from resistance and speed through the standard appended-power relation, and the marine module reports the required shaft power and the resulting propulsive coefficient so the result is a design quantity rather than a raw force.
Which resistance number to design against
The useful hull-design question is not "what is the resistance" but "which component would moving it buy me". Skin friction scales with wetted surface and roughness, so it responds to coating and to hull form. Wave-making resistance is set by the volume distribution fore and aft at a given Froude number, so it responds to a fuller bow or a finer run. Form resistance lives in the stern, where separation begins. Reporting the three separately turns one number into three levers.
Froude number is the nondimensional group that governs wave-making behaviour, and it sets which speed band a hull is being evaluated in. The ITTC-1957 powering formula, used for the appended-power estimate, is defined on exactly that scaling, so a resistance figure quoted without its Froude number is not comparable to anything.
Frequently asked questions
What is form drag versus wave-making drag?
Form drag is the pressure-driven resistance from the hull shape under an effectively flat surface, dominated by the stern separation. Wave-making drag comes from the energy carried away in the waves the hull generates, and depends on hull speed, Froude number and the volume distribution.
Try it now
The page you are reading is a static, crawler-readable summary. The interactive tool runs in your browser — nothing is uploaded.
Open CFD Lab Back to home